Returns numerous data, including Drive Condition ID and Engine Speed*ī5 is Engine Idle RequestB6 is Engine Stop Request*ģ codes per message frame, BCD encoded. Similar to PID 13, but = Ī0 = Power Take Off (PTO) status (1 = active) not usedĭistance traveled with malfunction indicator lamp (MIL) onįuel Rail Pressure (relative to manifold vacuum) (Includes malfunction indicator lamp (MIL) status and number of DTCs.) If Mode 2 PID 02 returns zero, then there is no snapshot and all other Mode 2 data is meaningless. The exceptions are PID 01, which is only available in Mode 1, and PID 02, which is only available in Mode 2. Note that modes 1 and 2 are basically identical, except that Mode 1 provides current information, whereas Mode 2 provides a snapshot of the same data taken at the point when the last diagnostic trouble code was set. Again, not all vehicles will support all PIDs and there can be manufacturer-defined custom PIDs that are not defined in the OBD-II standard. The expected response for each PID is given, along with information on how to translate the response into meaningful data. The table below shows the standard OBD-II PIDs as defined by SAE J1979. Vehicle manufactures are not required to support all modes.Įach manufacturer may define additional modes above #9 (e.g.: mode 22 as defined by SAE J2190 for Ford/GM, mode 21 for Toyota) for other information (e.g.: the voltage of the Traction Battery in a HEV). Control operation of on-board component/system Show pending Diagnostic Trouble Codes (detected during current or last driving cycle) Test results, other component/system monitoring (Test results, oxygen sensor monitoring for CAN only) Test results, oxygen sensor monitoring (non CAN only) Clear Diagnostic Trouble Codes and stored values They are, the $ prefix indicating a hexadecimal number: There are ten modes of operation described in the latest OBD-II standard SAE J1979. The scan tool reads the response, and shows it to the technician.A device on the bus recognizes the PID as one it is responsible for, and reports the value for that PID to the bus.The scan tool sends to the vehicle’s bus (CAN, VPW, PWM, ISO, KWP.Typically, an automotive technician will use PIDs with a scan tool connected to the vehicle’s OBD-II connector.

These codes are part of SAE standard J/1979, required to be implemented in all cars sold in North America since 1996. P-codes, or OBD-II PIDs On Board Diagnostics “Parameter IDs”, are codes used to request data from a vehicle, used as a diagnostic tool.

Obdwiz abs commands